EN - 27
If deflector does not follow full range of travel:
1. Push deflector remote forward.
2. Loosen adjusting nuts on cable support
bracket on side of chute deflector
(Figure 25).
3. a. To adjust the deflector lower:
Slide cable up and tighten top nut.
b. To adjust deflector higher:
Slide cable down and tighten bottom
nut.
4. Check travel and repeat adjustment as
necessary.
DISCHARGE CHUTE
(Figure 26)
If chute does not stay in position while
throwing snow or if chute does not rotate
freely, adjust the cable under the gear cover
so the chute lock fingers engage or
disengage the locking gear.
If chute does not stay in position:
Loosen the cable by loosening the rear
adjustment nut, and then tightening the
forward adjustment nut against the bracket
until the lock arm engages the gear teeth.
If chute does not rotate freely:
Tighten the cable by loosening the forward
adjustment nut, and then tightening the rear
adjustment nut against the bracket until all
cable slack is removed and lock arm engages
teeth. (Figure 26).
SPEED SELECTOR ADJUSTMENT
(Figure 27)
To adjust:
1. Disconnect adjustment pivot pin from
speed selector lever by removing
hairpin.
2. Place the speed selector on the control
panel in the fastest forward speed
position.
3. Turn the speed selector lever straight
down towards the ground as far as it will
go.
4. Thread the adjustment pivot pin along
the shift rod until it aligns with the mating
hole on the speed selector lever. Insert
the pivot pin into hole.
Figure 24
Control Lever Nut
Figure 25
Adjustment
Nuts
Figure 26
1. Forward Adjustment Nut
2. Rear Adjustment Nut
3. Lock Arm
