Areva MiCOM P125, Техническое руководство, Страница: 14 / 362

Pxxxx/EN SS/B11
Page 8/10 Safety Section
7.4 Environment
The equipment is intended for indoor installation and use only. If it is required for use in an
outdoor environment then it must be mounted in a specific cabinet or housing which will
enable it to meet the requirements of IEC 60529 with the classification of degree of
protection IP54 (dust and splashing water protected).
Pollution Degree – Pollution
Degree 2
Altitude – operation up to
2000 m
IEC 61010-1: 2001
EN 61010-1: 2001 Compliance is demonstrated by reference to safety
standards.
8. CE MARKING
Marking
Compliance with all relevant European
Community directives:
Product safety:
Low Voltage Directive - 73/23/EEC
amended by 93/68/EEC
EN 61010-1: 2001
EN 60950-1: 2001
EN 60255-5: 2001
IEC 60664-1: 2001 Compliance demonstrated by reference to
safety standards.
Electromagnetic Compatibility Directive
(EMC) 89/336/EEC amended by
93/68/EEC.
The following Product Specific Standard
was used to establish conformity:
EN 50263 : 2000
Compliance demonstrated via the Technical
Construction File route.
Where applicable :
II (2) G
ATEX Potentially Explosive
Atmospheres directive
94/9/EC, for equipment.
The equipment is compliant with Article 1(2) of
European directive 94/9/EC. It is approved for operation
outside an ATEX hazardous area. It is however
approved for connection to Increased Safety, “Ex e”,
motors with rated ATEX protection, Equipment Category
2, to ensure their safe operation in gas Zones 1 and 2
hazardous areas.
CAUTION – Equipment with this marking is not itself
suitable for operation within a potentially explosive
atmosphere.
Compliance demonstrated by Notified Body certificates
of compliance.
Radio and
Telecommunications Terminal
Equipment (R & TTE)
directive 95/5/EC. Compliance demonstrated by compliance to the Low
Voltage Directive, 73/23/EEC amended by 93/68/EEC,
down to zero volts, by reference to safety standards.