Arctic Cat M4000 2016, Руководство оператора

Страница: 51 / 60

47
0746-807
Ski Wear Bars
The ski wear bar is a replaceable bar
attached to the underside of the ski. The pur-
pose of the wear bar is to assist in turning
the snowmobile, to minimize ski wear, and
to maintain good steering control. If the
snowmobile is operated primarily in deep
snow, ski wear bar wear will be minimal;
however, if the snowmobile is operated on
terrain where the snow cover is minimal, the
ski wear bar will wear faster. To maintain
positive steering characteristics, Arctic Cat
recommends that the ski wear bars be
checked before each use and replaced if
worn beyond 1/2 of the original diameter.
Ski wear bars are available from an autho-
rized Arctic Cat Snowmobile dealer.
Removing Ski Wear Bars
1. Using Front End Lift (p/n 5639-
151), elevate the front of the snow-
mobile.
2. Remove the lock nuts securing the
wear bar to the ski.
3. Remove the wear bar from the ski.
Installing Ski Wear Bars
1. Move the wear bar into position on
the bottom of the ski.

NOTE: If installing a double-offset
wear bar, the carbide edge should be
directed to the outside of the ski.
2. Align the wear bar studs with the
holes in the ski; then install the lock
nuts. Tighten to 15 ft-lb.
Adjusting Ski Stance
ZR/XF

NOTE: Local laws and/or regula-
tions as to maximum width of the ski
stance on these snowmobiles may
be applicable. Always comply with
the maximum width laws and/or reg-
ulations when adjusting ski stance.

NOTE: Ski stance can be increased/
decreased by 2.5 cm (1.0 in.).
1. Place the front of the snowmobile on
a support stand.
2. Remove the cotter pin; then remove
the slotted nut and cap screw secur-
ing the ski assembly to the spindle.
Remove the ski. Account for the
rubber damper, inserts, and washers.
3. To increase ski stance, place ski
stance spacer to the outside of the
spindle and adjust the damper.
0746-797
4. To decrease ski stance, place ski
stance spacer to the inside of the
spindle and adjust the damper.
0746-796
5. Apply an all-temperature grease to the
non-threaded portion of the cap
screw; then slide the cap screw
through the ski accounting for the rub-
ber damper, inserts, and washers.
! WARNING
Operating the snowmobile with
excessively worn ski wear bars may
result in a loss of steering control.