Arctic Cat M4000 2016, Руководство оператора

Страница: 36 / 60

32

NOTE: Repeat steps 4 and 5 for each
cable; then compare the measure-
ments to the APV Cable Length chart.

NOTE: The measurements must be
within the specifications from the
chart. If the measurements are
within specifications, no adjustment
is necessary (proceed to step 8). If
they are not within specifications,
proceed to step 6.
6. Loosen the jam nut on the cable to
be adjusted; then using the adjusting
nuts, lengthen or shorten the housing
as needed.
7. Once the proper length has been
attained, hold the adjusting nut in place
and tighten the jam nut securely.
8. Place the cable housings into posi-
tion in the servomotor. Secure the
cable housings with the cable holder.
Battery (Electric Start)
These sealed batteries after being in ser-
vice require regular cleaning and
recharging in order to deliver peak per-
formance and maximum service life. The
following procedures are recommended
for cleaning and maintaining sealed bat-
teries. Always read and follow instruc-
tions provided with battery chargers and
battery products.

NOTE: Battery maintenance may
be done by the snowmobile owner if
qualified to do so. If the owner does
not feel qualified, take the snowmo-
bile to an authorized Arctic Cat
Snowmobile dealer for this service.
This service is at the discretion and
expense of the snowmobile owner.
To remove and charge the battery, use the
following procedure:
1. Remove the torx-head screw from
the rear underside of the seat; then
remove the seat.
2. Remove the negative battery cable
and ground wire; then remove the
positive cable.

NOTE: For installing purposes
prior to removing the battery, note
the routing and securing locations of
the cables and harness wires.
3. Remove the two screws and lock
nuts securing the battery bracket/
solenoid to the seat-base; then move
the bracket up and out of the way
and remove the battery.
746-170A
CAUTION
Assure the cables are rotated and
secured properly to avoid contacting
exhaust components.
! WARNING
Improper handling or connecting of a
battery may result in severe injury
including acid burns, electrical burns,
or blindness as a result of an explo-
sion. Always remove rings and
watches. Any time service is per-
formed on a battery, the following
must be observed: keep sparks, open
flame, cigarettes, or any other flame
away. Always wear safety glasses.
Protect skin and clothing when han-
dling a battery. When servicing a bat-
tery in an enclosed space, keep the
area well-ventilated.
! WARNING
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to the
state of California to cause cancer
and reproductive harm. Wash hands
after handling.
! WARNING
Avoid spillage and contact with skin,
eyes, and clothing.