Arctic Cat M4000 2016, Руководство оператора

Страница: 42 / 60

38
1. Measure the outside circumference
of the drive belt. The belt should be
within the recommended range in
circumference (see appropriate spec-
ifications sheet).
2. Measure the outside width of the
drive belt. The belt should be within
the recommended range in width.
3. Check the belt for cracking, fraying, etc.
If any of the specifications or conditions
are unsatisfactory, replace the drive belt.

NOTE: Drive belts should be pur-
chased from an authorized Arctic
Cat Snowmobile dealer, as Arctic Cat
drive belts are made to exact specifi-
cations and of quality material. Belts
made by other manufacturers may
not be of the same specifications or
quality and, therefore, usage could
result in poor performance and pre-
mature belt failure.

NOTE: Before starting the snowmo-
bile in extremely cold temperatures,
the drive belt should be removed and
warmed up to room temperature.
Once the drive belt is at room tem-
perature, install the drive belt.
Also, new drive belts have a break-in
period of approximately 25 miles. After
installing a new drive belt, drive the
snowmobile for 25 miles at 3/4 throttle or
less. By revving the engine up and down
(but not exceeding 60 mph), the exposed
cord on the side of a new belt will be
worn down. This allows the drive belt to
gain its optimum flexibility and will
extend drive belt life.

NOTE: Changing a drive belt can
be done by the snowmobile owner if
qualified to do so. If the owner does
not feel qualified, take the snowmo-
bile to an authorized Arctic Cat
Snowmobile dealer for this service.
This service is at the discretion and
expense of the snowmobile owner.
Removing - 6000/8000/ZR
4000 RR
1. Set the brake lever lock; then
remove the left-side access panel.
2. Thread Removal/Installation Tool
clockwise into the driven clutch
until the movable sheave opens far
enough to remove the drive belt.
0749-025
743-067B
3. When the sheaves are fully apart,
pull up on drive belt and roll belt
over stationary sheave until it is free
of the driven clutch.
4. When the belt is free of driven
clutch, remove the belt from the
drive clutch.
Installing - 6000/8000/ZR
4000 RR
1. Place the belt (so the part number
can be read) between the sheaves of
the drive clutch.
2. With the sheaves fully apart, roll the
belt over the stationary sheave.
3. With the drive belt properly posi-
tioned in the drive clutch and driven
clutch, turn the belt tool counter-
clockwise and roll the belt back and
forth to allow the driven clutch
sheaves to fully close.
CAUTION
Never run the engine with the drive
belt removed. Excessive revving of the
engine could result in serious engine
damage and drive clutch failure.
6000/8000
ZR 4000 RR