Arctic Cat M4000 2016, Руководство оператора

Страница: 14 / 60

10
B. High Beam Indicator
The indicator is on whenever the high
beam mode is selected by the headlight
switch.
C. Low Oil Indicator
The indicator is designed to alert the snow-
mobile operator when the oil in the oil
injection tank gets below a prescribed level.
Once the indicator illuminates during oper-
ation of the snowmobile, the operator must
periodically monitor the level of oil in the
reservoir and must fill the reservoir the next
time gasoline is added to the gas tank.
If the indicator does not go out or if the
engine does not start, take the snowmo-
bile to an authorized Arctic Cat Snowmo-
bile dealer. If not under warranty, this
service is at the discretion and expense of
the snowmobile owner.
If the indicator does not go out or if the
engine does not start, take the snowmo-
bile to an authorized Arctic Cat Snowmo-
bile dealer. If not under warranty, this
service is at the discretion and expense of
the snowmobile owner.
D. Low Fuel Indicator
The indicator illuminates whenever the
gas in the gas tank is low.
E. Coolant Temperature/
Battery Voltage/Intake Air
Temperature/Exhaust
Temperature Display
This bar display shows coolant tempera-
ture, battery voltage, intake air tempera-
ture, and exhaust temperature. Press the
Lower Left Button to change which
parameter is being displayed. Press and
hold the Lower Left Button to see the
actual values associated with the mode
selected.
F. Fuel Level Display
This bar display shows the approximate
amount of gas remaining in the gas tank.
G. RPM/Speed/Clock/
Altimeter
Press the Upper Left Button to cycle the
left screen between RPM and speed.

NOTE: When RPM is displayed on
the left screen, the right screen will
display speed, clock, or altimeter.
When speed is displayed on the left
screen, the right screen will display
RPM, clock or altimeter.
Press the Upper Right Button to cycle the
right screen between speed, RPM, clock,
and altimeter.
Press and hold the Upper Button on the
speed-side of the gauge to shift between
standard (MPH/miles/Fahrenheit) and
metric (km/h/kilometers/Celsius).
Press and hold the Upper Button on the
RPM-side to view maximum RPM. This
value is reset each time the ignition key is
turned off.
With the clock mode selected by pressing
the Upper Right Button, press and hold the
Upper Right Button to set the clock. The
option of selecting the 12-hour or 24-hour
clock is available; press the either Left But-
ton to alternate between the two modes.
Next, press the Lower Right Button to set
the clock. Press either Left Button to set the
hours; then press the Lower Right Button to
set the minutes. Press either Left Button to
set the minutes. When the proper time has
been set, press the Lower Right Button to
return to the main gauge display.
With the altimeter mode selected by
pressing the Upper Right Button, press
and hold the Upper Right Button to set
the current altitude by using either Left
Button. When the proper altitude has
been set, press the Lower Right Button to
return to the main gauge display.
CAUTION
If the indicator is illuminated, stop the
engine immediately and allow it to cool
down. If unable to either determine or
remedy the problem, take the snowmo-
bile to an authorized Arctic Cat Snow-
mobile dealer for service. If not under
warranty, this service is at the discretion
and expense of the snowmobile owner.