9
NOTE: The altimeter readout is
based off barometric pressure and
may require calibration as weather
conditions change.
To set/calibrate the altimeter to an estab-
lished altitude with altimeter selected on
the display screen by pushing and hold-
ing the select button for a minimum of
two seconds, the acronym CAL will be
displayed on the readout screen for one
second; then the altitude value will flash.
Push the increment button to increase the
displayed altitude; push the decrement
button to decrease the displayed altitude.
Pushing and holding a button will accel-
erate the number display.
NOTE: If MPH has been selected in
the speed readout, the altitude value
will be displayed in feet. If kph has
been selected in the speed readout,
the altitude value will be displayed in
meters.
To reset the maximum altimeter readout
with the maximum altimeter displayed,
push and hold the select button for a min-
imum of two seconds.
E. RPM/MPH (kph)
By pushing the increment button once,
the RPM and MPH will be displayed
(one on the readout screen and one with
the needle). By pushing the button once
again, the functions will be reversed.
By pushing the increment button (with
speed being displayed) for more than two
seconds, the display will change between
standard mph or metric kph.
With RPM displayed on the readout
screen by pushing and holding the incre-
ment button, maximum RPM will be dis-
played on the readout screen. The
maximum RPM readout will reset when
the decrement button is pushed (while
maximum RPM is displayed).
F. Fuel Level Display
This bar display shows the approximate
amount of gas remaining in the gas tank.
G. Service Icon
On electric start models, the icon should
briefly illuminate each time the key is
turned to RUN or START, and engine is
started; then it should go out when the
engine starts. If the icon stays illuminated
(on electric start models) or it illuminates
while the engine is running, the system is
receiving input that is outside of its estab-
lished parameters. If the icon illuminates
indicating an error, take the snowmobile
to an authorized Arctic Cat Snowmobile
dealer for service. If not under warranty,
this service is at the discretion and
expense of the snowmobile owner.
H. Odometer/Trip-Meter
(1)/Trip-Meter (2)/Hour-
Meter
By pushing the decrement button, the
readout screen will display odometer,
trip-meter (1), trip-meter (2), and hour-
meter. To reset the trip meter with the trip
meter displayed, push and hold the decre-
ment button until the display is cleared.
The hour-meter readout will not reset.
Deluxe Digital Gauge
(6000)
CWI-051A
A. Coolant Temperature
Indicator
The indicator and LOW TEMP display
will cease to flash when the engine
reaches proper operating temperature.
If the coolant temperature rises too far
above proper operating temperature, the
indicator will flash a warning (alert). If the
coolant temperature rises to a critical point
above proper operating temperature, the
indicator will cease flashing and will
remain constantly illuminated.
Содержание M4000 2016
Страница 1: ...2016 OPERATOR MANUAL ZR XF M 4000 6000 8000 www arcticcat com...
Страница 7: ...3 Snowmobile Safety Rules...