KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
DANGER
- To avoid possible electric shock, special care should be taken if water
is employed in the use of vivarium equipment. For each of the following situations,
do not attempt repairs yourself; return the appliance to an authorised service
facility or discard the appliance.
This product is designed for indoor use and the illumination of Vivariums and
Aviaries only and will provide a good and safe service life, provided that these
instructions are followed. Failure to do so may result in serious personal injury or
property damage.
If you are in any doubt about the installation or operation of this product, please
consult a qualified and experienced electrician.
Check that the voltage and frequency rating on the product label is the same as
your electrical supply before proceeding further.
WARNING
- To guard against injury, basic safety precautions should be observed,
including the following:
• Disconnect from the mains supply socket before maintaining the Luminaire.
Never pull on the cord to remove the plug from the socket, instead grasp the
plug and pull to disconnect.
• Regularly check the security of all your Luminaire legs or suspension mechanism parts.
• The Luminaire can get HOT. Never touch the Luminaire while it is operating,
allow adequate time for it to cool before attempting any maintenance.
• If electrical components of the appliance get wet unplug the appliance
immediately. If the appliance shows any sign of water leakage disconnect from
the power supply immediately.
• To avoid the possibility of the appliance plug or socket getting wet, position it
to one side of the wall socket. A ‘drip loop’ should be arranged for each cord
connecting to a power socket. The ‘drip loop’ is that part of the cord below
the level of the socket, or connector, which prevents water travelling along the
cord to the socket.
See illustration 1.
• Do not operate the Luminaire with defective or faulty lamps – circuit damage
may occur. Replace lamps promptly with a lamp of the correct type and
wattage. It is advisable to keep spare lamps available.
• Do not use the appliance other than for its intended use. The use of non-
Arcadia attachment or accessories is not recommended and may cause an
unsafe condition.
• Do not install or store the appliance where it will be exposed to extremes of
weather or temperatures below freezing.
Lamp installation
Ensure lamps are of the correct type and wattage.
To remove the lamp, pull the retaining ring (A) clips out and up to remove it from
the lamp holder.
See Illustration 2.
To remove the lamp pull it out directly from the lamp holder, do not twist it or lever it.
To insert the lamp, push the lamp directly into the lamp holder ensuring the lamp
pins are correctly aligned with the terminal holes. The lamp is fully seated when it
latches into place.
See illustration 3.
5
UK
Содержание D3 Plus Desert RAU24R
Страница 2: ...1 2 3 4 A...
Страница 3: ...5 6 7 100 mm 3 7 100mm...
