24-04-13
Page 6 of 12
3786417
12. Remove the two bolts in the base of the
control box and reposition them into the
more centralised holes.
13. Replace the 4 solenoids, making sure
they line up with the holes in the base.
14. Replace the 2 cap screws, washers and
nuts removed in step 13 above into
original holes.
15. Replace the black cover and refit the
three cover screws. (DO NOT OVER
TIGHTEN)
16. Bolt the control box bracket to the
control box.
17. Fit the two grommets into the round
holes then thread the cable through.
18. Mount the control box bracket onto the
top pan, using M8 bolts, flat washers
and flanged nuts. Use the cable ties to
ensure the winch cables are secure,
clear of moving parts and sharp edges
and tie them together.
