24-04-13
Page 5 of 12
3786417
WINCH FITMENT
7. For ease of access the winch gearbox
handle needs to be rotated. To do this,
first undo all the cap screws and
carefully lift the gearbox clear of the
winch body so as not to damage the
gasket. (
Do not lift the gearbox more
than a couple of millimetres
) Rotate
the gearbox 144° anti clockwise.
Re-fit
the caps-crews.
8. Remove the cover from the control box.
9. The three main power cables that go
from winch to control box must be
changed over using longer cables from
bolt kit. Make sure that you identify the
colour codes on the new cables before
re-fitting the control box cover.
NOTE: This must be done for whatever
winch is to be fitted to the bull bar.
10. If fitting the
XP 9.5 winch
, remove the
cover from the control box. Remove the
two cap screws, nuts and spacer
washers that hold the four solenoids in
place.
11. Remove the four solenoids from the
base of the control box using the copper
bus bar as an aid and hold to one side.
