24-04-13
Page 12 of 12
3786417
43. If no winch is fitted to the bar, wrap
rubber extrusion around winch cover.
44. Place stainless steel washers over the
winch cover fixing holes located on the
top middle face of the winch bar.
45. Place the winch cover on top of the bar
inline with the mount holes. Bolt together
using the M6 button head stainless steel
screws and M6 nuts.
46. Place the double-sided tape along the
top edge of the licence plate. Fit number
plate to bar using M6x16 bolts, washers
and flange nuts. The two photos display
the number plate positions for winch and
non-winch bars.
47. There are two diameter 16 holes located
on the top face of the bar. If no CB
aerials are fitted the holes can be
covered with the plastic plugs provided in
the fitting kit.
48. When finished make sure all bolts are
tightened and that all wiring is clear of
hot, sharp and moving parts.
