User’s Manual
28
Video Blind
Check the
Video Blind
box to set up a video blind event.
When the transmitter detects that more than 70% of a
camera is blinded by anything, it considers the video blind
as an event.
y
Sensitivity
: Adjust the sensitivity for the video blind.
y
Activation Time
: Adjust the duration that a video blind
should last to be considered a video blind event. The
transmitter will not consider any video blind as a video
blind event if it is shorter than the preset time.
y
Use Ignoring Time
: Set up the event ignoring time.
The transmitter will ignore video blind events occurring
during the preset time.
y
Event Action
: Check the box for each action the transmitter will take whenever it detects a video
blind event.
í
Alarm Out
: Select to trigger an alarm-output signal.
í
Send Email
: Select to send an Email. Selecting a camera in the
Image Attachment
field attaches
the event detected image file (.JPG) when sending an Email.
í
Remote Callback
: Select to send a message to remote sites and select the desired remote sites.
í
Move PTZ to
: Select the desired preset number to move a PTZ camera to the previously saved preset
location. You must set up preset locations of PTZ cameras during
3.2 Setup
–
Camera/Audio Setup
.
NOTES:
y
Video blind events might NOT be detected for a camera with a very noisy image especially when set
for low Sensitivity values.
y
You must properly configure the settings related to each event action during the
4.6 Event – Event
Action
setup to enable event actions.
System Event
Check the
System Event
box to set up a system event.
The transmitter checks and reports the system and alarm-in
status.
y
System
: Select the check interval. The transmitter
sends an email when the system is operating.
y
Alarm In
: Select the check interval. The transmitter
sends an email when there is no alarm-in event status
change.
NOTE:
You must properly configure the
settings
during the
4.6 Event – Event Action
setup to send an email.
Содержание CTINT1000
