Aras CTINT1000, Руководство пользователя

Страница: 12 / 42

User’s Manual
6
2.3 Rear Panel
Network Port
Audio Out
Audio In
Video In
Video Termination
Resistance Switch
RS485 Port
DC 12V Out
Alarm Output
GND
Alarm Input
Power In
y
Network Port:
Connect a Cat5 cable with an RJ-45 jack. Refer to Chapter 3 – Operation & Basic
Configuration; 3.2 Setup, IP Address Setup for details on network connection setup. When using a PoE
switch, the transmitter can be supplied with power over Ethernet. (Refer to the PoE switch manufacturer’s
manual for details.)
y
Audio Out:
Connect to an amplifier. (Line-out)
y
Audio In:
Connect to an audio source. (Line-in or Microphone)
y
Video In:
Connect coaxial cables from the video sources (NTSC or PAL).
y
Video Termination Resistance Switch: Push down the video termination resistance switch to
turn it on.
y
RS485 Port:
Connect to a PTZ camera. Connect TX+/RX+ and TX-/RX- of the PTZ camera to the +
and – (respectively) of the transmitter. Refer to Chapter 3 – Operation & Basic Configuration; 3.2 Setup,
Camera/Audio Setup and the PTZ camera manufacturer’s manual for configuring the RS485 connection.
y
DC 12V Out:
Connect the power wires from the camera (12 VDC). The camera can be supplied power
from the transmitter when using 12 VDC power. C and – of the camera to the + and – (respectively)
of the transmitter.
y
Alarm Output:
Connect an alarm-out device to the NO (Normally Open) and C (Common) connectors.
NO is a relay output which sinks 0.5mA @ 125 VAC and 1A @ 30 VDC
.
y
GND:
Connect to the ground side of the alarm inputs.
y
Alarm Input:
Connect alarm-in devices. Mechanical or electrical switches can be wired to the AI
(Alarm-In) and GND (Ground) connectors. The maximum voltage should not exceed 5V. The threshold
voltage for NC (Normally Closed) is above 4.3V and for NO (Normally Open) is below 0.3V, and it should
be stable at least 0.5 seconds to be detected.
y
Power In: Connect
two wires from the power adapter (12 VDC or 24 VAC). The transmitter starts
booting as soon as power is applied.
NOTES:
y
The transmitter does not have amplified audio output, so you will need a speaker with an amplifier.
y
To make connections on the Alarm Connector Strip, press and hold the button and insert the wire in
the hole below the button. After releasing the button, tug gently on the wire to make certain it is
connected. To disconnect a wire, press and hold the button above the wire and pull out the wire.
y
Camera and audio surveillance may be prohibited by laws that vary by region. Check the laws in your
area before using this product for surveillance purposes.
CAUTION: The transmitter restarts after the power adaptor is disconnected from the transmitter
when switching the power source from 12 VDC or 24 VAC to PoE.