ARAG Skipper LT, Инструкция по установке, эксплуатации и обслуживанию

Страница: 34 / 56

34
USE
7.4 Spraying a field
Fig. 101
Let's consider to wish to spray field by parallel lines,
but only after spraying field borders.
• Switch Skipper LT on (par 6.1).
After self-diagnosis routine, system asks if you wish to continue a previous job (Fig. 101).
Press
ESC to start a new spraying job.
• Select guidance mode you wish to use during spraying job: execute function (par. 8.2.2).
• Set at the beginning of field to spray (Fig. 102).
• Start spraying by working the relevant activation command according to system in use:
press USER key and enable spraying job on machine.
• Start driving along field border. During this path, message
Mark A?
is displayed.
Fig. 102
marking Points a and b
• While driving field border you will mark two points A and B
(as described under par. 8.3.1 - function ).
This step is essential to allow Skipper LT to guide you, during the job, along
tracks parallel to the reference one, obtained by marking points A and B.
We recommend that you mark A and B at the ends of a straight
length as long as possible and while vehicle is moving: the
longer the marked length across points A and B, the lower the
error caused by your deviation while driving.
Fig. 103
• Once straight line A/B ( t0 ) is tracked, the whole field could be sprayed
along tracks parallel to it (Fig. 103), following the reference tracks that will
be displayed (Fig. 104).
Fig. 104