ARAG Skipper LT, Инструкция по установке, эксплуатации и обслуживанию

Страница: 18 / 56

18
6.5.2 - GPS antenna
Within every item, active options are marked with

.
Fig. 33
Antenna position
Fig. 34
Indicate the position of the antenna with respect to the point where tractor is spraying (crop spraying
boom, spreader plate, etc.).
In the example shown in Fig. 34, antenna
a
is installed in
Front
of the spraying boom
b
.
Warning: Before setting this item, modify the
Antenna distance
(Fig. 35): if
Antenna
distance
is zero, item
Antenna position
cannot be modified.
Antenna distance
Fig. 35
Indicate distance
c
between antenna and work point (Fig. 35).
Depending on entered value, the displayed sketch will change accordingly.
DGPS
Fig. 36
Allows you to enable the DGPS differential correction function (SBAS): SBAS differential correction
signal is a free signal only available in some areas world-wide that ensures a higher work accuracy.
WARNING: this function can only be used in Europe (EGNOS), United States of America
(WAAS) and Japan (MSAS).
Enabling / disabling the differential correction during the job could lead to a rather big measurement
error between the vehicle and the tracks sprayed until that moment (
e
in Fig. 36). The following
passes will be correctly measured (equidistant one from the other).
In the example shown in Fig. 36, press
OK
to continue job. It is recommended to perform a track
alignment JUST AFTER THIS, using function "Align" (par. 8.2.4 - F4 Align).
PROGRAMMING - MACHINES SETUP
Par.
6.3
Scrolling menu items.
Increase / decrease data Quit the function or
data changes Confirm access or
data changes. Shift the
cursor Reset / disable
data