33
Exit the function
or data change
Confirm access
or data change
Scroll
(LEFT /
RIGHT)
Delete
selected
character
Data
decrease
of data
Scroll
(UP /
DOWN)
Enter
selected
character
Par.
AUTOMATIC SECTION CONTROL
• Sections overlapping limit
Set the acceptable threshold for overlapping of already-sprayed areas.
When this value is exceeded, the monitor restores the correct spraying: depending on the section management mode enabled (par. 13.5 Boom
section management), the monitor will prompt the operator to close the relevant valves or proceed to the automatic closing of the spraying points.
Sections overlapping limit 0%
Sections overlapping limit 100%
0%
Fig. 63
100%
Fig. 64
• Perimeter overlapping limit
Set the acceptable threshold for overlapping of spraying with respect to field perimeter.
When this value is exceeded, the monitor restores the correct spraying:
depending on the section management mode enabled (par. 13.5 Boom section management), the monitor will notify the operator that the section
valves spraying outside the field perimeter must be opened or closed, or proceed to the automatic opening/closing of the spraying points.
The following conditions are required in order to use this setup:
- Drawing the field perimeter (red line in the figures) using the function
- Enabling automatic section control: the icon
on the guidance screen indicates that automatic control is enabled.
Perimeter overlapping limit 0%
Perimeter overlapping limit 100%
The alert asking to close / open section valves will be displayed following a
minimum overlapping (0%) across the field perimeter.
The alert asking to close / open section valves will be displayed ONLY when the
machine is spraying across the entire field perimeter (100%).
PERIMETER
OF THE FIELD
Fig. 65
PERIMETER
OF THE FIELD
Fig. 66
> > > 11.4.11 Working parameters
CONTINUES > > >
ADVANCED SETTINGS
"IMPLEMENT"
