Arachnid galaxy 3, Руководство оператора

Страница: 7 / 36

Section 3
Galaxy 3 Basics
This section instructs you how to assemble your Galaxy 3 once
it is unpacked. This section also explains some basic terms and
explains the layout of several important areas of the Galaxy 3.
3.1 Assembly
1. Insert the four set screws provided into the top of the
lower cabinet.
2. Place the upper cabinet assembly on the lower cabinet.
3. Unlock the bezel.
4. Flip down the monitor and monitor bezel.
5. Secure the upper cabinet to the lower cabinet using the
four wing nuts provided.
6. Feed the wiring harness and connector through the hole
in the lower cabinet to the upper cabinet and connect to
the IOB.
7. Insert the eye bolt into the hole provided on the back
of the Galaxy 3.
8. Secure the eye bolt to the back of the machine with
a washer on the inside and outside and nut provided.
9. Locate a wooden wall stud behind the Galaxy 3. We
are going to use that to anchor the Galaxy 3 to the
wall. The drywall can be up to 5/8” thick in front of
the wall stud
10. Measure up from the floor 44” and mark the spot on
the wall.
11. Drill 2-1/2” pilot hole with a 3/32” bit.
12. Slide a washer up to the eyelet of the 3/16 x 2-3/16”
Eye Lag Screw.
13. Secure the Eye Lag Screw and washer to the wall
stud.
14. Connect the two Eye bolts together with the chain
provided.
15. Close and secure the monitor and monitor bezel.
IMPORTANT: The Galaxy 3 should not be operated
until it is placed with its back against a wall in an area
where bystanders will not get struck by a dart.
3.2 Basic Terms
Marquee - The Marquee is designed to catch the eye of
the players and entice them into playing the game .
Darthead - The target at which players throw their darts at
the Galaxy 3 has a 15” darthead and a 13” darthead.
Catch Screen - The part around the target that catches any
missed darts.
Target Illumination Panels - These LED panels illumi-
nate the target in clear white light. They are also used in
attarct mode to catch the players eye.
Navigation Buttons - Use the Up, Down and Enter but-
tons to navigate the menus of the Galaxy 3.
Monitor - A 19” widescreen HD Monitor.
Coin Door - This is where the Coin Mechanisms and
Dollar Bill Acceptors are installed.
Darthead Latch - Use this to unlock the darthead and flip
it to the other side.
2 Galaxy 3 Operating Manual
Marquee
Darthead
Catch Screen
Target
Illumination Panels
Monitor
Coin Door
Navigation
Buttons
Darthead
Latch
Hot Button
Reader