AQUAPHOR
PROFESSIONAL
WATER TREATMENT
L.Tolstoi
2A, Sillamäe,
40231 Estonia
www.pro.aquaphor.com
International: +372 356 2204 21
Skype: aquaphor market.pro
e-mail: [email protected]
13
- output control signal on / off solenoid valve flushing (normally open, passive)
14 - common connector (using together to control signal outputs 9, 10, 11, 12 and 13)
15, 16
–
terminals of power supply in 220 V
Connectors from top to bottom on the right:
1
–
input high water level sensor in the storage of permeate (normally open, closes in
the case of low water level in the storage of permeate).
2
–
relay input of over-pressure pump (normally closed, is opened in the case of
excessive pressure).
3
- relay input of low pressure permeate (normally open, closes at a given pressure).
4
- sensor input of lack in feed water (normally open, closes at the presence of water).
5 - a contact of external switch, ECS (system works when the contact is closed). ECS
may be controlled by push-button switch on the control panel, if the pushbutton is not
used, lock out the contacts 5 and 8.
6- The reset signal can be connected to the reset button on the control panel which
uses to unlock and reset the alarm in the event of high or low pressure.
8 - the general conclusion to be used for the sensor signal contacts 1,2,3,4,5 and 6.
Connectors from left to right at the middle:
22 - input wire of electrode conductivity measurement (green wire).
23 - input wire of electrode conductivity measurements (red wire).
25 - input wire of electrode conductivity measurement (white wire).
26 - input wire of electrode conductivity measurement (yellow wire).
Other connectors including contacts 7, 17, 18, 19, 20, 21, 24 have no internal
connection.
Mode of operations:
When the controller is turned on, the lamp lights
«
POWER
»
, and the display panel
will show the conductivity value. Turn ECS (« CONTROL OF RO »to" AU
TO "),
the system will start to filter the water, if you turn off the ECS, the system will be in
“hold” mode.
Press the "SET", the display panel will show "1000" (the constant of electrode). Press
the button "SET" again, and the display will show the following menu items:
1.000
200.0
A.050
B.050
C - 99
