AQUAPHOR
PROFESSIONAL
WATER TREATMENT
L.Tolstoi
2A, Sillamäe,
40231 Estonia
www.pro.aquaphor.com
International: +372 356 2204 21
Skype: aquaphor market.pro
e-mail: [email protected]
8.5 Connecting and configuring the controller
red
green
white yellow
Side control
cell conductivity meter
side control input
of power
status
Attention: The controller is working with low-power relays, using large inductive
load must be applied with relays or contactors. Direct connection will damage the
contact or shorten its life.
Designation:
ZJ - intermediate relay
CJ - magnetic contactor
The drawing shows the connectors which are located on the rear panel. The panel is
equipped with the following connectors:
Connectors from top to bottom on the left:
9
- exit control signal on / off high-pressure pump (normally open, passive)
10
- output control of the upper limit of the conductivity (normally open, passive)
11 - output control signal on / off the low-pressure pump (normally open, passive)
12
–
output control signal on / off control input of the valve (normally open, passive)
