AQUASTREAM ULTIMATE
than 1 second) maximum current is 1.5 A. If output current exceeds 1.5 A or 1 A
for a longer period of time, the output will be permanently disabled and a system
alarm (with alarm buzzer) is triggered. To reactivate the output, the aquastream
ULTIMATE (or the complete PC) has to be disconnected from power for a short pe-
riod of time. The fan output is short-circuit proof.
If required, multiple fans can be connected using standard fan splitter cables as
long as the total current does not exceed output specifications.
Pin assignment:
Pin 1: GND
Pin 2: 0-12 V DC output
Pin 3: Speed signal
Pin 4: PWM signal
6.8.
6.8.
6.8.
6.8. Connector for temperature sensor
Connector for temperature sensor
Connector for temperature sensor
Connector for temperature sensor
Connector for a temperature sensor.
Compatible sensors:
●
Temperature sensor inline G1/4 (53066)
●
Temperature sensor inner/outer thread G1/4 (53067)
●
Temperature sensor G1/4 (53147)
●
Temperature sensor plug&cool (53025)
●
Temperature sensor 70 cm (53026)
7.
7.
7.
7. Operation of the aquastream ULTIMATE
Operation of the aquastream ULTIMATE
Operation of the aquastream ULTIMATE
Operation of the aquastream ULTIMATE
7.1.
7.1.
7.1.
7.1. Initial operation
Initial operation
Initial operation
Initial operation
Turn off your PC or remove the PSU mains cable if the PSU does not have a power
switch. Remove all cables of the PSU (e. g. from non removable disks, optical stor-
age drives or graphic cards). Take special care to disconnect the 4pin or 8pin
ATX12V power supply connector from the motherboard as well. Connect the pow-
er connector of the aquastream ULTIMATE to an available SATA power plug of the
power supply unit.
To operate your aquastream ULTIMATE while
filling the system, you have to either start the PC
power supply with the enclosed ATX start plug
or attach the pump to a second power supply
unit.
To start the power supply unit, plug the ATX
start plug onto the 20pin or 24pin ATX power
supply connector of the PSU. After you have at-
tached the plug to the PSU and turned on the
mains switch of the PSU, the PSU and pump will immediately power up. Proceed
by filling the water cooling system with coolant.
- 8 -
Aqua Computer GmbH & Co. KG
© 2016-2018
Gelliehäuser Str. 1, 37130 Gleichen
computer
aqua