AQUASTREAM ULTIMATE
Please note that pump speed and the resulting changes in flow rate have only a
minor influence on temperatures in a typical water cooling setup. This mode may
therefore not effect the expected results.
11.6.
11.6.
11.6.
11.6. Pump mode curve controller (Advanced Controller Package only)
Pump mode curve controller (Advanced Controller Package only)
Pump mode curve controller (Advanced Controller Package only)
Pump mode curve controller (Advanced Controller Package only)
This mode can be used to automatically adjust pump speed depending on the cur-
rent temperature reading of one of the up to four available temperature sensors.
The controller curve can be configured by assigning output values to 16 corre-
sponding temperature values. The output values in percent correlate to the pump
speed range from 3000 to 5500 rpm. So a value of 50 % correlates to a pump
speed of 4250 rpm, a change of 1 % correlates to a speed change of 25 rpm. If
the selected speed cannot be attained, the pump controller will use the highest sta-
ble rotation speed instead.
In the aquasuite, controller curves can easily be adjusted using drag & drop and
curves can automatically be generated from start and end points. In the graphical
curve display, the currently displayed area can be changed using the following
methods:
●
Mouse wheel movements will zoom in and out.
●
A double click on an axis will reset zoom level for this axis, a double click
into the diagram will reset both axes.
●
Selecting an area on an axis will zoom this axis to this area, selecting an
area in the diagram will zoom both axes to this area.
●
Mouse movement while right button is pressed will move the displayed area
of the diagram.
11.7.
11.7.
11.7.
11.7. Pump mode flow controller (Advanced Controller Package only)
Pump mode flow controller (Advanced Controller Package only)
Pump mode flow controller (Advanced Controller Package only)
Pump mode flow controller (Advanced Controller Package only)
This mode can be used to automatically adjust pump speed depending on the cur-
rent flow rate. This requires either an additional external flow sensor or the pur-
chase of the virtual flow sensor software extension. The desired flow rate can be
configured between 30 to 300 liters per hour.
12.
12.
12.
12. Fan configuration
Fan configuration
Fan configuration
Fan configuration
aquasuite: Select “Fan” from the device list below the “aquastream ULTIMATE”
entry. In the upper area, current fan data is displayed as plain text as well as in a
diagram. Select the desired mode of operation below the diagram.
Device menu: Select “Fan” from the menu list and confirm by pressing the middle
key.
12.1.
12.1.
12.1.
12.1. Fan mode
Fan mode
Fan mode
Fan mode power preset
power preset
power preset
power preset
If power preset mode is selected, you can manually set the desired output power of
the fan output. The values in percent correlate to the either the voltage range from
© 2016-2018
Aqua Computer GmbH & Co. KG
- 17 -
Gelliehäuser Str. 1, 37130 Gleichen
computer
aqua