Aplex ARCDIS -107, Руководство пользователя

Страница: 29 / 50

ARCDIS-1XX User Manual 29
Communications:
RS-232
Baud Rate:
19200 and 9600 baud rate selection
Resolution:
1024x1024 (10-bit A/D converter inside)
Power Input:
5V ~ 12V DC
Power Consumption:
12V: 24mA+ i where (i=v/touch screen sheet R)
5V: 20mA+ i where (i=v/touch screen sheet R)
Board Size:
6.0 x 2.5cm
Portrait:
Support 90
∘
to 279
∘
screen rotation
Static Protection:
ESD device (optional)
3.4 Installation of the 9036 Controller Board
Follow the steps below to install the 9036 control board:
1. Power down your computer and display, and open your display or system case. Find space on
your system and attach the control board to your system with screws. The control board has
industry standard 3
φ
screw holes.
2. Find the white 6-pin right-angle connector (on the left in the image above [see Figure 3.1]). The
power cable is pin 1 and pin 2. Solder the power and ground wire to the system. The RS-232 cable
is for pins 3 to 6. Attach the RS-232 cable
’s D-sub connector to a COM port at the back of the
computer.
3. Find the white 9-pin right-angle connector (on the right in the image above [see Figure 3.1]). Attach
the female end of the touch screen cable to this connector. If you attach the cable of a 4-/5-/8-wire
touch screen to pins 1~5/1~6/1~9, attach the male end of the cable to the touch screen tail.
4. Mount your touch screen to the display.
5. Find the onboard DIP switch (on the upper right of the image above [see Figure 3.1]). This switch