ANTTI 408050, Инструкция по установке и эксплуатации

Страница: 14 / 24

14
Scale
01-2020
Antti-Teollisuus Oy
SHORT INTRODUCTION TO THE PROGRAMMING
Press the PAR key to start programming. The meter then goes to the selection mode of the
programming menu.
Press the F1 key down several times to select the programming menu that you wish to
edit.
As the PAR key is depressed a second time, the first parameter that may be edited, is
displayed. The display toggles between Display 1 (parameter) and Display 2 (set value for
the parameter).
To change the parameter, depress the F1 and F2 keys repeatedly until the desired value
is displayed. After defining the parameter, save it and move to the next parameter to be
edited by pressing the PAR key. Continue programming in this way until all the values that
you wish to change have been processed. Finally depress the DSP key to resume the
display mode.
If you get lost or confused during the procedure, press the DSP key to restart.
The next step is basic calibration of the scale under programming menu 1.