Anritsu MS8608A, Руководство по эксплуатации, Страница: 45 / 338

Section 1 General
1-23
• Option 35: Extension of frequency upper limit to 7.9 GHz
(only for MS8608A)
Outline
Frequency band
Pre-selector range
Average noise level
High Power Input
Low Power Input
Residual response
Frequency response
2nd harmonic distortion
1 dB gain compression
Maximum dynamic range
Expands upper frequency limit to 7.9 GHz.
Band 0: 9 kHz to 3.2 GHz, Band 1
−
L: 1.6 to 3.2 GHz, Band 1
−
: 3.15 to 6.3 GHz
Band 1+: 6.2 to 7.9 GHz
3.15 to 7.9 GHz (Band 1
−
L, 1
−
, 1+)
At RBW 300 Hz, VBW 1 Hz
At input attenuator 20 dB
≤−
100 dBm + 0.8
×
f [GHz] dB (3.15 to 7.9 GHz, Band 1)
At input attenuator 0 dB
≤−
120 dBm + 0.8 f [GHz] dB (3.15 to 7.9 GHz, Band 1)
≤ −
90 dBm (3.15 to 7.9 GHz, Band 1, RF ATT: 0 dB, Input: 50
Ω
termination)
50 MHz as reference
At input attenuator 30 dB (High Power Input) or 10 dB (Low Power Input), 18 to 28
°
C
±
1.0 dB (3.15 to 7.9 GHz, Band 1)
At input attenuator 20 to 82 dB (High Power Input) or 2 to 62 dB (Low Power Input)
±
2.0 dB (3.15 to 7.9 GHz, Band 1)
*After executing pre-select tuning.
≤ −
90 dBc (1.6 to 3.95 GHz, Band 1, mixer input level:
−
10 dBm)
≥
0 dBm (3.15 to 7.9 GHz, Band 1)
≥
120 dB
−
0.8
×
f [GHz] dB (3.15 to 7.9 GHz, Band 1)
• Option 36: Power Meter Maximum Frequency Extension (6 GHz)
Outline The frequency renge of the power meter function of measurement software is extended to 6 GHz.
Frequency Range
3 to 6 GHz
Level Rangr MS8608A : 0 to +40 dBm : High power input
–20 to +20 dBm : Low power input
MS8609 : –20 to +20 dBm
Measurement Level Accuracy After zero-point calibration
MS8608A :
±
10%
MS8609A :
±
10%
• Option 46: Auto power recovery
Outline Cancels the power switch on front panel and automatically recovers to power-on after power failure.
* This equipment enters the standby state when the line has to be disconnected and
reconnected, because power switch on front panel doesn’t have latch function.
If this equipment is built into remote systems, please install this option.
• Option 47: Rack mount (IEC)
Outline Attachment of rack mount which meets IEC spec
The standard tilt handle is eliminated when rack mount kit is attached.
• Option 48: Rack mount (JIS)
Outline Attachment of rack mount which meets JIS spec
The standard tilt handle is eliminated when rack mount kit is attached.