ANK DAC5.1 Signature, Руководство по монтажу

Страница: 65 / 104

As mentioned we will be wiring these connections later in the build.
12.2 Mounting the board into the Chassis
There are 5 holes on the digital board for mounting and the 5 th screw is the ground. Locate the
unpainted ground area on the back of the chassis and you can then position the DAC PCB into
the correct location. Suggesting you just loosely put one screw into the ground hole to position
the board in the chassis – We will be needing to wire to this board and its easier when the
board is not installed down in the chassis – we can secure at the end of the build.
Figure 41 - Unpainted area on chassis
If you would like to wire up the inputs to the digital board – 1) SPDIF input 2) CON Switch and
3) XLR then you can go near the end of the manual on Page 86 in the section:
Rear of DAC5.1 Chassis Connections
61