ANGHINETTI & CAMPTEL TV/S, Инструкция по эксплуатации

Страница: 24 / 48

IRONING BOARDS
TV/S TV/SG1F TV/SG2F
ANGHINETTI & CAMPTEL S.r.l
Via XX Settembre 95 - 26040 - Gussola (Cr) Italy
Tel.: +39 0375 / 260885
•
Fax: +39 0375 / 260666
•
e-mail:
info@anghinetti.com
Page
24
of
48
– Rev. 01
Description of operation (for TV/SG1F TV/SG2F)
Open water supply
REF C figure 8
Ensure the boiler drain valve is closed
REF
B figure 8
N:B
ONLY FOR TV/SG1F TV /SG2F MODELS
Based on model FIG. 9 , position the
different switches at “1”
Wait for the machine to warm-up once switches
are on.
In models fitted with boiler, activate the steam
activation buttons during commissioning, at first
boiler load end, for the air present therein to bleed.
The ironing board is equipped with thermostat
Ref.6 , automatically regulated by the
thermoregulator upon reaching of temperature.
The arm sleeve board is equipped with automatic
thermostat.
The irons are provided with thermoregulators
regulating its operation based on the chosen
fabric.
The pressure indicator
REF 7 fig. 9
shows the
pressure inside the boiler upon reaching of
3.5
bar . Light REF 1 fig. 9 switches off allowing use
of steam. A control unit controls water level in
boiler circuit, allowing its automatic reset.
Indicator
Ref 1 fig. 9 shows boiler heating
elements operation (on, active heating elements).
The following indicator also works as alarm,
switching the water filling pump off if there is no
water.
Indicator flashes, switches the filling pump off
after a while and the control unit will emit an
alarm.
6.3. U
SE
The operator must be in front of machine with
figure 8B regulators on his/her right.
From here, the operator has pedal and
REF.13 fig.
8B in front, to press the ironing board's exhaust
fan activation pedal.
Clothes can be placed on the ironing board from
this position.
Iron clothing using the iron (previously adjusted
according to fabric to be ironed), once clothing
has been placed on the ironing board.
Using the board's steam button and vacuum to
cool clothing to remove any creases on the fabric.
The ironing board's vacuum power can be
increased or decreased using the lever below the
ironing board.
REF.C fig. 10
FIGURE 10
6.4. S
WITCH
-
OFF PLACING
OUT OF SERVICE STOP
T
HE SWITCH
-
OFF PROCEDURES
are the
following :
Position switches figure 9 at “0”
Close water inlet
REF C FIGURE 8
Position the iron on relative mat