IRONING BOARDS
TV/S TV/SG1F TV/SG2F
ANGHINETTI & CAMPTEL S.r.l
Via XX Settembre 95 - 26040 - Gussola (Cr) Italy
Tel.: +39 0375 / 260885
•
Fax: +39 0375 / 260666
•
e-mail:
Page
23
of
48
– Rev. 01
7: Arm sleeve connection (to be
removed if machine is fitted with arm)
8: Ironing board mat and cloth
9: Cloth tensioning springs
10: Clothes holding board cloth
11: Clothes holding tube
12: Clothes holder fixing screws
13: Vacuum activation pedal
14: Non-slip feet
15: Silicon rest
16: Iron
17: Tube holder springs
Insert the tube holder springs in
REF.2 fig. 8A,
connect the irons (if present) to sockets REF.5
fig. 8A, and the steam tubes to REF.4 fig. 8A .
If the machine is fitted with arm sleeve, tighten it
REF.7 fig. 8A, connect plug to socket REF.6 fig.
8A.
Assemble all remaining components as in fig. 8B
6.
USE INSTRUCTIONS
6.1.
I
NTRODUCTION
ANGHINETTI
&
CAMPTEL
S.r.l
,
recommends reading (
paragraphs 1-2-
3-4)
before use. It declines any liability
for accidents due to negligence and
non-compliance with the above
The Machine was conceived for use by one
Operator only.
Personnel in charge of working on the Machine
must have (or acquire through adequate training),
the following requirements and also be aware of
this Manual and all Safety information
:
Sufficient general and technical knowledge
to understand the Manual;
Knowledge
of
the
main
accident-
prevention and hygienic standards
Know how to behave in case of
emergency, where to find the personal
protective equipment and how to correctly
use it
6.2.
O
PERATION ADJUSTMENT
AND SWITCH
-
ON
Once installation is completed, see
paragraph 5.3
Proceed as follows, activating the different
utilities
N.B. more or less buttons may be present
depending on model
figure 9
Below is the list of switches:
1: Boiler heating elements operation light
2: Boiler unit switch-on button (the boiler
and water filling pump circuit operates in
automatic by activating the following
button)
3-4: Iron switch-on button (if present)
5: Arm sleeve switch-on button (if present)
6: Ironing board temperature adjustment
7: Boiler pressure indicator (Max 3.5 bar)
