English
To carry out this operation, proceed as follows.
1 - Switch the appliance off and leave it to cool
(see page 10).
2 - Turn off the circuit-breaker to disconnect it from
the electrical mains.
3 - Drain and filter the oil (see page 13) .
4 - Remove and clean the baskets and the basket
support structure
(A)
.
5 - Use the lever
(B)
to swing the heating elements
(C)
into the vertical position.
6 - Apply a food-grade detergent to the inside of
the well.
7 - Rinse the well with drinking water and drain.
8 - Apply a specific product or a water and vinegar
solution to the well to remove the detergent res-
idues.
9 - Rinse, empty and dry the well.
10 - After use, clean the accessories with a suitable
grease-remover product. If possible, wash in
the dishwasher.
Important
When using water for routine cleaning,
check that there are no traces of water left
in the well, on the accessories and in the
drain line before refilling with oil.
CLEANING THE WELL, BASKET SUPPORT AND ACCESSORIES
The appliance has been tested before being put
into service.
The information provided below is intended to as-
sist in the identification and correction of any anom-
alies and malfunctions which might occur during
use.
The user can solve some of these problems him-
self, but for others specific technical knowledge or
skill is required, and so they must only be carried
out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Important
For all requirements contact the agents or
the headquarters of Angelo Po which can
be found in the contacts section of the web-
site http://www.angelopo.com.
TROUBLESHOOTING
Fault
Cause
Remedy
The heating elements do not come
on
Electrical connection not made cor-
rectly
Check the connection of the electri-
cal wires
Safety thermostat tripped
Carry out the appliance reset (see
page 13)
A
C
B
