AMX Enova DVX-2100HD, Руководство по эксплуатации/справочник

Страница: 36 / 111

Wiring and Device Connections
25 Enova DVX-2100HD 6x2 All-in-One Presentation Switcher Operation/Reference Guide
VIDEO INPUTS (1-4)
The four DVI-I VIDEO INPUT connectors on the rear panel are used to connect source input devices to the
DVX-2100HD (FIG. 39). The DVX-2100HD routes video from connected source input devices to the
connected output devices. The four DVI-I VIDEO INPUT connectors correspond to source select button 1-4
on the front panel.
These numbered inputs correspond to the numbered INPUT SELECT pushbuttons on the front panel.
The following table describes the pinout configuration of the DVI-I VIDEO INPUT connectors:
Each VIDEO INPUT connector supports DVI-D, as well as RGBHV, S-video, Composite, and Component
inputs, using the appropriate conversion cables. Refer to the
Cable Details and Pinout Information section on
page 33 for cable details and pinout information for each cable type:

DVI-D Male to DVI-D Male Single-Link Cable section on page 33

DVI-A Male to 5-BNC Male Cable section on page 35

DVI-A Male to Triple RCA Male Cable section on page 36

DVI-A Male to S-Video Male Cable section on page 38

DVI-A Male to HD15 (VGA) Male Adapter section on page 39
FIG. 39 VIDEO INPUT (DVI-I connectors)
The DVI Input connectors on the DVX-2100HD are DVI-I (integrated digital/analog)
connectors. These connectors support both DVI-A (analog) and DVI-D (digital)
inputs.
DVI-I Input Ports - Pinouts and Signals
Pin Signal Pin Signal Pin Signal
1 TMDS Data2- 9 TMDS Data1- 17 TMDS Data0-
2 TMDS Data2+ 10 TMDS Data1+ 18 TM
3 TMDS Data2/4 Shield 11 TMDS Data1/3 Shield 19 TMDS Data0/5 Shield
4 n/c 12 n/c 20 n/c
5 n/c 13 n/c 21 n/c
6 DDC Clock [SCL] 14 +5 V Power 22 TMDS Clock Shield
7 DDC Data [SDA] 15 Ground (for +5 V) 23 TMDS Clock +
8 Analog vertical sync 16 Hot Plug Detect 24 TMDS Clock -
C1 Analog Red
C2 Analog Green
C3 Analog Blue
C4 Analog Horizontal Sync
C5 Analog Ground
If a DVI source is attached before setting the input to DVI, you may need to reboot
the source for it to recognize the DVI input description information required by the
DVI standard.