AMX endeleo UDM 1604, Руководство пользователя

Страница: 52 / 94

5-8
UDM1604-USG – 2.0 - 0606
Section 5
Operating the UDM Hub
• Device must be added to the system as a
Device and be assigned its learned protocol.
• Port must be configured for Passthrough Mode.
5.4.1 Configuring a Device for Passthrough Mode
The device needs to be added to the system as both an input and as a
device.
(1) Cable the device as an input coming into the rear of
the chassis e.g. into Input A as for a normal input.
(2) Add the device as an input in the Inputs option.
(3)
Learn the device’s protocol using IR Learning – refer to
the Protocols section and Advanced Administration
section of this manual.
(4)
Add the device into the Devices option as normal and
assign it its IR protocol.
Note;
Ensure the relevant IR blaster port is cabled up to the
device also e.g. if the device is connected to Input A
cable IR port 1 to the device, if Input B cable IR port 2
to the device etc.
(5) The device has now been added as an Input (and as a
device).
5.4.2 Configuring a Port for Passthrough Mode
To configure a port to access a Device in Passthrough Mode;
(1) Select the Status option.
(2) Once the main Status screen is visible click on User
Control for the correct port.
Figure 5-10: Placing a port into Passthrough Mode