AMX endeleo UDM 1604, Руководство пользователя

Страница: 28 / 94

2-8
UDM1604-USG – 2.0 - 0606
Section 2
Input configuration
(2) To enter compensation mode push button A then
button B on the RX02 remote control.
(3) The amber LED at the Cat5 port on the RX unit will
start to flash – indicating the RX is in compensation
mode.
(4) Use the buttons on the RX02 remote control to adjust
appropriately the following up or down;
• Sharpness;
• Gain and
• Red, Green and Blue.
(5) Once the image displayed is of an acceptable quality
push the Esc button on the RX02 remote control to exit
compensation mode.
Warning!
The compensation settings will be specific to this RX
unit and stored internally i.e. if this RX unit is
replaced or swapped out the compensation settings
will travel with the RX unit. It may therefore be
necessary to recompensate the RX / replacement RX
if this RX unit is to be used elsewhere or is being
replaced.
Infrared RX port