Amsco 36 H, Руководство оператора

Страница: 24 / 152

3-2
P129394-068 Operator Manual Installation Verification
3.1.3 Electrical Service
❑
Electric single-phase service to the unit must be as specified on
the Equipment Drawing and on the Machine Data Plate.
❑
Electric single-phase service requires a clearly marked
disconnect with lockout-tagout capability located near the
sterilizer.
❑
Electric single-phase service should be on a separate circuit,
and not tied into circuits containing large reactive loads (e.g.,
motors).
❑
The protective earth ground must be connected to terminal
block TB-1 in the sterilizer power box.
❑
Three-phase power for vacuum pump must meet specifications
on the equipment drawing.
❑
Verify proper rotation of the vacuum pump by observing pump
rotor shaft.
❑
Three-phase service requires a clearly marked disconnect with
lockout-tagout capability located near the sterilizer.
3.1.4 Sterilizer Final Check
❑
Chamber leveled properly.
❑
Door opens and closes smoothly.
❑
Door locked switches adjusted correctly.
❑
Chamber strainer in place.
❑
Rack and shelves and/or loading car operates correctly.
❑
Paper loaded in printer.
❑
Printer ribbon properly installed.
❑
Warranty labels properly applied.
3.1.5 Cycle Operation
❑
Unit powers up correctly.
❑
Run Leak Test cycle – leak rate is to be less than 1.0 mm Hg/
minute (1.3 mbar/min).
❑
Verify operation of a typical cycle (270°F [132° C] prevacuum).
WARNING – EXPLOSION
HAZARD: This sterilizer is not
designed to process
flammable compounds.
!