AMPHIBICO Dive Buddy EVO HD Elite, Инструкция по эксплуатации

Страница: 11 / 25

Rear LCD Monitor (continued)
Settings for the rear LCD monitor are located
on the inside of the rear bulkhead and are
described as follows.
COLOR To adjust color saturatio n
BRIGHT. To adjust the brightness
CONT. To adjust the contrast
WARNING:
IT IS IMPORTANT TO REMOVE BATTERIES
FROM BATTERY HOLDER AFTER EVERY
USE. FAILURE TO DO SO MAY DRAIN THE
BATTERIES OVER TIME AND CAUSE
SEVERE DAMAGE TO THE UNIT.
Closing the housing
1. While the housing is open, inspect the two o-rings and the sealing surface for dirt and debris.
If necessary, clean them with a lint free tissue. Make sure that the two o-rings and the sealing
surface are clean. Then apply a small amount of lubricant to the o-rings.
NOTE: If you have to change your o-rings, make
sure you are using the o-rings provided with the
package. Using different o-rings than those in the o-
ring kit may cause the housing to leak and result in
damage.
Silicone grease provided with the o-
ring kit.
2. Make sure the camera and the
cables don't block the sealing surface. If cables get pinched,
the system might be intermittent or not functioning at all. Once the camera is completely in and
the saddle is locked, engage the latch by turning it clockwise.
3. Make sure the o-rings are well placed before locking the latch. Turn the latch until a positive
click is felt.
www.amphibico.com