AMPHIBICO Dive Buddy EVO HD Elite, Инструкция по эксплуатации

Страница: 12 / 25

Replacing the bayonet lens
1. To remove the lens, push and hold the
button on the lower right of the front bulkhead
and then turn counter clockwise until the lugs
are free from the bayonet ring. Pull gently on
the lens to release it.
2. Remove the rear cover from the new
bayonet mounted lens and place it on the
previously installed lens for safe keeping. Make
sure the seals on the bottom part of the lens are
clean and free from dust and debris.
3. Put a small amount of lubricant on the o-ring
seals and the sealing surface of the housing.
4. Line up the bayonet lug marked by a hole
with the printed dot on the front bulkhead of the
housing. Push the lens all the way until it sits
on the bayonet ring and turn clockwise. You will
hear a positive click and the lens will lock into
place.
Installing Accessories
All Amphibico housings are provided with
brackets where optional accessories can be
mounted. On the Dive Buddy EVO HD housing,
these brackets have been machined directly on
the body. In fact, two T-brackets are
incorporated to it. A third one, which is basically
done to accommodate the carry handle, is
located on top of the body.
Accessories are provided with either thumb
screws, adjustable handles or setscrews.
Some of these accessories require
communication with the camera's electronics
Waterproof connectors need to be installed or
the housing to allow information to trave
through the electronics. For example, the
monitor needs to be hooked up to the
Af\
connector on the camera.
www.amphibico.com