1-78
S-104-100
Revised 09/2004
e-mail: [email protected]; [email protected]; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
TRIM KNIFE ADJUSTMENT
Adjusting for the relaxed position
The “relaxed” position is when the trim knife assembly is located over the right hand spreader stop and
away from the throat plate.
To adjust, loosen nut
A
and turn screw
B
counterclockwise or clockwise (counterclockwise will move the
trim knife assembly to the right; clockwise will move the trim knife assembly to the left) as necessary.
Once the adjustment has been made, re-tighten nut
A
.
Needle to Trim Knife
Lower the needle bar. The Knife should be set to pass by the needle without touching it. To adjust, loosen
screw
C
and move knife in or out as necessary. Once the adjustment has been made, re-tighten screw
C
.
Height of Trim Knife
The knife should be set so it clears the underside of the throat plate, as well as the top of the right hand
spreader stop. To adjust, loosen screw
D
and move up or down as necessary. Once the adjustment has
been made, re-tighten screw
D
.