1-54
S-104-100
Revised 09/2004
e-mail: [email protected]; [email protected]; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
STITCH COUNT ADJUSTMENT
To adjust the stitch count, loosen nut
A
and move slide link
B
forward or backward (forward
increases
the
number of stitches; backward
decreases
the number of stitches) as necessary. Once the adjustment has
been made, re-tighten nut
A
.
To
increase
or
decrease
the number of stitches in the eye portion of the buttonhole, perform the following
steps:
No eye buttonholes
(Adjustable Flybar Only)
Change the selector lever, located in the rear of the bedplate, to the “NO EYE” position by moving lever
C forward to the “No Eye “ position. Loosen screw
D
and move wedge
E
forward or backward (forward
increases the number of stitches, backward decreases the number of stitches.) This is done to control the
descent of roll
F
on the beveled portion of the wedge while the race is turning, and the buttonhole is being
sewn. Once the adjustment has been made, re-tighten screw
D
.
Eye Buttonholes
(Adjustable Flybar Only)
Change the selector lever, located in the rear of bedplate, to the “Eye” position by moving the lever
C
backward to the “Eye” position. The desired number of stitches in the eye is obtained by the position of
stop screw
H
. To adjust, loosen jam nut
G
, and move stop screw
H
in or out (in will increase the number
of stitches; out will decrease the number of stitches). This is done to control the descent of roll
F
on the
beveled portion of the wedge. Once the adjustment has been made, re-tighten jam nut
G
.