1-56
S-104-100
Revised 09/2004
e-mail: [email protected]; [email protected]; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
CUTTING STEEL AND KNIFE ADJUSTMENTS
6. Knife holder
G
(with knife inserted) must line up with the center of the prick-in. If it does no, loosen
screw
H
and screw
I
(located on both sides of the knife holder), and slide knife holder left or right ad
necessary. Once the adjustment has been made, re-tighten screw
H
and
I
.
7. The cutting lever must be in alignment with the knife. To check, manually pull the lever down. If not in
alignment with the knife, repeat step 4.
NOTE:
The knife must lined up in the center of the cutting steel. The cutting lever should be free of
binds and have no side play. In order to visually check the impression made by the knife onto the cutting
steel, the machine may be cycled under power without stitching. This is dome by raising lever
J
for a
short period of time, pressing start lever, and the machine will quickly make one complete cycle. See page
1-94 for knife ordering instructions.