Ametek Chandler Engineering 4207D, Руководство по эксплуатации

Страница: 12 / 47

2-2 SECTION 2 – OPERATING INSTRUCTIONS
Configuring the controller to perform a sample load program involves defining a series of
ramp and dwell segments.
Once the program exists, the program is executed by pressing the
Run button. To suspend
the program the Run/Hold button may be pressed briefly ( Hold light illuminates) and
restarted by pressing the Run/Hold button again.
To terminate the program, the
Run/Hold button is pressed until the Run light is Off . Press
the Auto/Man button to place the controller in manual mode.
Use the following procedure to define and run a program:
1.
Turn the system On .
2.
Press the Page button until the Prog menu appears.
3.
Press the Scroll button until the Segment number 1 is displayed ( SEG.n with the set
point value reading 1 indicates segment number 1)
4.
Press the Scroll button twice.
5.
Enter the segment type ( tYPE ). Use the Up/Down buttons to enter a ramp time ( rmP.t )
type.
6.
Press the Scroll button.
7.
Enter the target setpoint ( tGt ). This is the desired load at the end of the ramp, expressed
in units of Lbf/10.
8.
Press the Scroll button.
9. Continue the process of defining remaining segments. The maximum number of
segments is 8.
10.
The final segment type has a type End.
11.
Press the Run/Hold button to start the program.
12.
To stop the program, hold the Run/Hold button until the Run light turns Off .
Sample Controller Program
The following table provides the API Specification 10 programs for the controller.
Note: The indicated value on the controller and display must be multiplied by 10 for
the force in pounds-force (Lbf).