AmeriGlide RAVE, Служба установки

Страница: 13 / 28

13 // 28
Rave Stair Lift Manual | www.Ameriglide.com | 866-378-6648
20419 P/N: 630-00078 Rev E
COMPLETION PROCEDURES
8. Upon completion, two beeps will indicate that both remote controls have been
programmed.
9. Turn the “ON/OFF” switch to the “OFF” position (0).
10. Connect the 6-pin footrest and 8-pin chair wire harnesses to the chassis and
then turn the red “ON/OFF” switch to the “ON” position (I).
11. Test each remote control in both the up and down directions.
IV. COMPLETION PROCEDURES
A. TEST ARMREST CONTROL SWITCH
The optional key switch on the arm of the chair must be in the “ON” position to use the
remote call/send control.
Step 1: Ensure that the unit travels correctly by operating the armrest control switch
while standing in front of the unit.
Step 2: Depress the switch in the upstairs direction to move up. The lift will beep, wait
three (3) seconds and begin to smoothly accelerate upwards. The lift will continue to
move upwards as long as the switch is depressed.
Step 3: Release the switch and the lift will come to an immediate stop.
Step 4: Depress the switch in the downstairs direction to move down. The lift will beep,
wait three (3) seconds and begin to smoothly accelerate downwards.
Step 5:
Release the switch and the lift will come to an immediate stop.
Step 6: Run the chair all the way up and down the rail to ensure that the top of the seat
back has at least a 1/2 " clearance from the wall and any obstructions.
B. TIGHTEN BRACKETS
Step 1: Install and fully tighten the rail bracket mounting screws
—
four (4) screws per
bracket. For hardwood stairs, a pilot hold should be drilled first. For plywood or particle
board stairs care must be taken to prevent stripping.
Caution!
Do not ride on the chassis or lift until the install is complete.