AmeriGlide RAVE, Служба установки

Страница: 12 / 28

12 // 28
Rave Stair Lift Manual | www.Ameriglide.com | 866-378-6648
20419 P/N: 630-00078 Rev E
REMOTE CALL / SEND CONTROL OPERATION
III. REMOTE CALL/SEND CONTROL OPERATION
A. REMOTE CONTROL OPERATION
The optional key switch on the arm of the chair must be in the “ON”
position to use the remote call/send control.
Step 1: Press and hold the appropriate directional button on the front of
the hand control. The LED indicator light will turn green when a signal is
being sent.
The chair lift will operate with or without a rider. All safety sensors on the
chair lift are designed to continue to operate in their normal mode. The
LED light indicator on the armrest will also display the appropriate color.
Step 2: If the chair lift fails to respond, this may be an indication that
the batteries are discharged and need to be replaced. Remove the back
cover of the control and replace with commonly available AAA batteries,
ensuring that the polarity is correct.
B. REMOTE CONTROL RE-PROGRAMMING
All call/send controls are factory programmed. Re-programming is not
normally necessary during installation. In the event that the remote call/
send control needs to be re-programmed, it is essential to program
BOTH controls in one programming cycle. Do so by completing the
following:
1. Start with the red “ON/OFF” switch in the “OFF” position (0).
2. Disconnect the 6-pin footrest and 8-pin chair wire harnesses
from the chassis.
3. Press and hold the install switch (located on the top of the
chassis) in either direction.
4. Turn the red “ON/OFF” switch to the “ON” position (I), and
then release the install switch.
5. The lift will begin to beep rapidly (this means the first remote
control is ready to program).
6. Press and release the “UP” or “DOWN” button of the first
remote control (the first remote control is now programmed).
7. Press and release the “UP” or “DOWN” button of the second
remote control (the second remote control is now programmed).