AmeriGlide RAVE, Служба установки

Страница: 11 / 28

11 // 28
Rave Stair Lift Manual | www.Ameriglide.com | 866-378-6648
20419 P/N: 630-00078 Rev E
INSTALLATION PROCEDURES
Step 11: The armrest control is factory set
for right-hand operation. If the user prefers
to operate the armrest controls with their left
hand, loosen the single screw on the underside
of each armrest and slide each armrest
upwards. Disconnect the plug on the armrest
control, switch the armrests, and reconnect the
plug. Replace armrests and tighten screws.
Step 12: If the lift is equipped with the optional key lock, ensure that
the key switch on the armrest control is in the locked position (with
the key in the vertical position).
Step 13: Turn the red “ON/OFF” switch located on the top of the
chassis to the “ON” (I) position. You should hear a single beep and
the LED indicator light on the armrest control should cycle through a
test sequence, showing red, yellow and green respectively. If any of
the system controls or safety sensors are engaged the LED indicator
light will turn to yellow.
Step 14: If the LED indicator light is not green, check the safety
sensors:
1. Seat swivel sensor (seat should be in the locked
position)
2. Footrest lower sensor (check by pushing in on the
safety pan on the footrest)
3. Upper foot pan safety sensor (check by pushing on
the safety pan on the footrest).
4. Front foot pan safety sensor (check by pushing on the
safety pan on the footrest).
5. Uphill safety sensor (ensure nothing is blocking
upward passage)
6. Downhill safety sensor (ensure nothing is blocking
downward passage)
If the LED indicator light is still not green after testing sensors, turn
the unit off and recheck all wire plugs. Turn the unit on again and
recheck the LED indicator light cycle. When the LED indicator light
remains green the lift is ready to operate.
Step 11
Step 11
Step 12
Step 14
Step 13