American-Lincoln 6150, Инструкция по эксплуатации, Страница: 32 / 138

32 - FORM NO. 56041704 American-Lincoln
6150
HOPPER
The hopper houses the debris
compartment, the dust control
fi lter and the removable
dust baffl e. For maximum
performance and service life,
keep the hopper clean and
inspect the seals and fl aps
daily. Clean the hopper prior
to parking the sweeper at the
end of the day. A clean hopper
will make inspecting the fl aps
and seals much easier and will
prevent premature deterioration
of hopper components. Do not
leave the hopper full of debris
while in storage or when parked
for extended periods of time
TO CLEAN HOPPER
Once the hopper has been
emptied the insides of the
hopper should be rinsed out
with water.
TO CHECK HOPPER SEALS
The Hopper seals are important to positive dust control while sweeping. Damaged seals will reduce vacuum
pressure at the broom. Inspect for cuts, tears and proper positioning of the seal material. Replace all seals
that become damaged.
DUST CONTROL FILTER
The dust control fi lter should be checked daily for damage and cleaned if necessary. A damaged fi lter must
be replaced to prevent damage to other dust control system components. Inspect the fi lter for tears in the
fi lter media or excessive dirt lodged in the pleats. A tear in the fi lter media will allow dirt to pass through the
fi lter and can be easily seen as a dirty patch on the top side on the fi lter. Cleaning the fi lter is necessary when
the fi lter shaker fails to adequately clean the pleats.
TO CHECK THE DUST CONTROL FILTER
1. Park the sweeper on a smooth level surface. Turn the key switch to the “O” position and engage the
parking brake.
2. Raise the hopper lid for access to the fi lter compartment.
3. Turn the latch, lift the fi lter frame and remove the fi lter.
4. Inspect the panel fi lter for tears and clean or replace if necessary.
5. Reinstall
the fi lter, lower the fi lter frame and engage the fi lter latch.
6. Close the hopper cover.
TO CLEAN THE DUST CONTROL FILTER
Clean the dust control fi lter when the shaker fails to adequately clear the fi lter. The fi lter can be cleaned with
compressed air not to exceed 100psi.
To clean the fi lter with compressed air, apply the compressed air to the top of the panel to backfl ush the
lodged dirt from the fi lter pleats. Be careful to not damage the fi lter media while cleaning. The fi lter can
be cleaned with a solution of soap and water. If this cleaning method is used do not use the fi lter until it is
completely dried.
SERVICE INSTRUCTIONS
C0739 FIGURE 33
FILTER
COMPARTMENT
DUST
BAFFLE
HOPPER
SEALS
DEBRIS
COMPARTMENT
C-0739