American-Lincoln 6150, Инструкция по эксплуатации

Страница: 18 / 138

18 - FORM NO. 56041704 American-Lincoln
6150
DUST BAFFLE
The dust baffl e is located in the hopper and may be
removed for cleaning. The dust baffl e is mounted to the
hopper with two threaded knobs for easy removal.
The debris door must be opened to gain access to the
dust baffl e.
Remove and clean the dust baffl e when debris becomes
lodged in the baffl e passages.
To remove the baffl e, turn the two threaded knobs
counterclockwise and lift the baffl e off the studs.
To install the baffl e, position the baffl e on the studs and
turn the two threaded knobs clockwise.
HOPPER SAFETY ARM
The hopper safety arm is located near the right front
wheel well. The safety arm will prevent the hopper from
dropping unexpectedly during service/maintenance.
WARNING
The Hopper Could Drop Unexpectedly And Cause
Injury. Engage The Safety Arm Before Working
Under Hopper.
WARNING
For Safety Always Empty Hopper Before Servicing.
TO ENGAGE THE SAFETY ARM:
1. Empty hopper.
2. Set the parking brake.
3. Raise the hopper.
4. Lift safety arm to engage the slot on the hopper
frame.
5. When work has been completed, replace the safety
arm to the stowed position.
HOPPER FILTER COMPARTMENT COVER
The Hopper Filter Compartment Cover is located on the
top of the hopper and opens forward for access to the
fi lter compartment for service and inspection of the dust
control fi lter and operational hopper temp sensor.
Use the hand hold provided to open the cover.
Inspect the cover gaskets daily. Replace any cover gas-
kets that show signs of deterioration. Failure to maintain
the gaskets in serviceable condition will degrade dust
control at the fl oor and will result in less than minimal
sweeping performance.
DUST
BAFFLE
THREADED
KNOB
C-0726
DEBRIS
COMPARTMENT
COVER
HAND
HOLD
C-0776
HOPPER
SAFETY ARM
TO
ENGAGE
MODEL NO. SERIAL NO.
WARNING
C-0727
6150
C0726 FIGURE 20
C0727 FIGURE 21
C0776 FIGURE 22
SWEEPER CONTROLS/INSTRUMENTS