American-Lincoln 6150, Инструкция по эксплуатации

Страница: 19 / 138

American-Lincoln FORM NO. 56041704 - 19
6150
FILTER PANEL LATCH
The fi lter panel is located in the hopper fi lter
compartment and will need to be removed
periodically for cleaning or replacement. Removal
of the fi lter panel requires no tools. The hopper
cover must be opened to gain access to the fi lter
compartment. The panel fi lter is held in place by a
hinged frame and latch.
To remove the panel fi lter, turn the latch counter
clockwise and lift the hinged frame.
The panel fi lter can now be lifted out and cleaned or
replaced. (See “To Clean the Dust Control Filter” in
this manual).
To install the replacement panel fi lter, lower the
frame and turn the latch clockwise to lock the fi lter
in place.
HOPPER TEMP SENSOR (OPTION)
The temp sensor switch monitors the hopper
air temperature near the vac fan. When the
temperature of the air moving through the hopper
exceeds 140ºF the switch trips which turns off the
dust control fan and illuminates the hopper temp
light on the warning bank.
The hopper temp sensor is a resetable thermal
switch which is located in the hopper fi lter
compartment near the vacuum fan intake.
When the hopper temp light illuminates, carefully
investigate for a possible fi re in the hopper.
The sensor will not reset until the temperature in the
hopper has dropped below 133ºF.
To reset the temp sensor, press the reset button.
ENGINE COMPARTMENT LATCH
The engine cover encloses the entire engine,
radiator and hydraulic reservoir assembly. The
cover can be swung open to allow easy access to
the engine and hydraulics for service or inspection.
WARNING
Operate Only When Lids, Doors, And Access Panels
Are Securely Closed.
To open the cover, lift the cover latch lever up.
Swing the cover open.
The cover will latch automatically when the cover is
closed. After closing the engine cover, check to be
certain the latch has fully engaged.
Amer i can - L i nco l n
EN G INE
COMPARTM EN T
LATC H
L IF T TO OP EN
C - 0779
H OPP E R
T E MP E RATUR E
S EN SOR
C 0778
R E S E T
BUTTO N
PUS H
TO
R E S E T
C0777 FIGURE 23
C0778 FIGURE 24
C0779 FIGURE 25
SWEEPER CONTROLS/INSTRUMENTS
FI LT E R
PA NE L
LATC H
L IF T
F RAM E TO
R E MOV E
FI LT E R
FI LT E R
PA NE L
TUR N LATC H
TO R E L E AS E
C - 0777