TABLE 1 – ZODIAC INSPECTION FORM
Make / Model
____________________
Serial No.
_____________________
Airframe Hours
___________________
Type of Inspection
(Circle One)
Registration No: _________
Engine Hours: __________
50 100 500 1000
Symbols: + Indicates perform task, - Indicates do not perform task
Task
Refer to
Intervals
(Flight Hours)
Initials
50
100
500
1000
Propeller Group
1.
Check propeller bolts for torque and safeties.
2.
Inspect blades and hub for cracks, corrosion,
damage, etc.
3.
Inspect spinner and backing plate.
Engine Group
Danger
Ground magneto primary circuit before
working on engine.
1.
Check for oil/fuel leaks.
2.
Check for particles on oil suction screen and
sump drain plug.
3.
Drain oil and refill. Safety plug.
4.
Perform cylinder compression test.
5.
Clean the spark plugs. Adjust gap
6.
Check and set magneto timing. See 29.
7.
Check magneto breaker points and lubricate
breaker point felt.
8.
Clean oil suction and oil pressure screens
9.
Inspect the wet type foam air filer.
10.
Inspect the exhaust manifold for cracks
(carb and cabin heat shroud removed).
11.
Inspect the heat shrouds for cracks, etc.
12.
Inspect the motor mount fuselage and
engine attachment points and braces.
13.
Inspect the rubber engine vibration
isolating mounts for cracks damage, etc.
First bolt torque is at 5
hours.
Sensenich Continued
Airworthiness
Requirements. Also see
Appendix 1 of this
manual.
See Engine Operators
Manual.
Section 6.5
+
+
+
+
-
+
-
-
-
-
-
-
-
-
+
+
+
+
+
+
+
+
+
+
+
-
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
-
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
July 09
3.3
Inspection page 1 of 8