AMCI NR60E2, Руководство пользователя

Страница: 39 / 98

20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786

Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
NR60E2 User Manual
S
ET THE
IP A
DDRESS AND
P
ROTOCOL
39
3.3c Use the Embedded Web Server (continued)
3.3c.3 Network Setup Page (continued)
5) If the values are accepted, the following pages will be displayed while the data is being written to the unit.
Wait for the pop up window to appear before cycling power to the NR60E2. Cycling power
before this window appears may corrupt the non-volatile memory of the NR60E2. The
NR60E2 will also flash the Network Status LED red to indicate that power must be cycled.
Figure T3.5 Write Configuration to Flash Memory Pages
6) Once instructed to do so, cycle power to the unit. You can now enter the new IP address into the address
bar of your web browser to reconnect with the NR60E2. Note that if you changed the subnet that the
NR60E2 is on, you may have to change the IP address of your computer’s network port.
3.3d Use the AMCI NET Configurator Utility
PREREQUISITE: You must know the present IP address of the NR60E2. The factory default address is
192.168.0.50. If you do not know the address, use the information in section 3.3b, Use the NR60E2 IP
Address Switches , to set the Address Switches to ‘999’. This sections starts on page 35. This sets the IP
Address to 192.168.0.50 regardless of the data stored in flash memory.
These instructions assume that the Address Switches are set to “999”. If they are instead set in
the range of “001” to “254”, the last octet of the IP address is set by the Address Switches.
With these settings, the subnet can be changed, but the last octet of the programmed address
must match the switch settings.
PREREQUISITE: Task 2.1: Power Wiring Installation found on page 29. You must be able to power the
NR60E2.
PREREQUISITE: Task: 2.2: Ethernet Wiring Installation , found on page 30. You must attach your
NR60E2 to your computer.
PREREQUISITE: The network interfaces on your computer must be on the same subnet before you can
communicate with an NR60E2. Refer to Configuring Network Interfaces , which starts on page 21, for addi-
tional information
This method allows you to change the IP Address, Subnet Mask, and Default Gate-
way values. If the NR60E2 was sold in or after September, 2019 the embedded web
server should be used to set the IP Address instead of this method. The unit’s
serial number can be used to determine the date of manufacture. The first for dig-
its of the serial number are the month and year of manufacture.
CHANGES TO
ONCE THE WRITE
IS COMPLETED