41
10.4 Option SmartElec Controller
10.3.1 Keypad
The button will allow you to navigate.
The button will allow you to increase the setting.
The button will allow you to decrease the setting.
fig.12. SmartElec
Pressing the button will advance the display to
‘
U 0’
. This denotes a single or No. 1 air curtain.
*
Pressing the button increases this number to a
maximum of 15. This should be set to show the
actual number of air curtains in the network. Each
air curtain can be independently set by first entering
the air curtain number, then pressing to access
the parameters described below.
Pressing the button again will advance the
display to the outlet SET temperature (default =
‘S’
25
)
This is denoted by the prefix ‘
S
’ followed by the
required set temperature in °C. Temperature
settings between 16° and 35°C can be set (16°C
equals maximum savings).
Use the or buttons to increase/decrease
the desired setting.
10.3.2 Operation
When power is applied to the controller, the display
will illuminate with the air outlet sensor temperature.
This is denoted by the prefix ‘t’ followed by the
actual temperature at the probe in
°C.
Pressing the button again will advance the
display to the HEAT setting (default =
‘H’ 25
).
This is denoted by the prefix ‘
H
’ followed by either a
‘0’
for HEAT OFF (AMBIENT ONLY) or ‘1’ for HEAT
ON (default =
‘H1’
)
Use the or buttons to increase/decrease
the desired setting.
Содержание AIRBLOC ACR Series
Страница 43: ...43 Notes...