Amano 07082C, Руководство оператора

Страница: 7 / 88

7
Electrical Connection Instructions
EN
230 VOLT MACHINES
INSTRUCTIONS FOR CONNECTION
TO THE POWER SUPPLY
AND THE ELECTRICAL GROUND
CAUTION:
To avoid damage to the machine operate only
on AC frequency and electrical voltage shown
on the nameplate. Make sure you have the
correct frequency and voltage before connect-
ing the power cord to an outlet.
This product must be grounded. If it should malfunction or
breakdown, grounding provides a path of least resistance
for electric current to reduce the risk of electric shock. This
product is equipped with a cord having an equipment-grounding
conductor and grounding plug. The plug must be inserted into
an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
WARNING:
Improper connection of the equipment-
grounding conductor can result in a risk
of electric shock. Check with a qualified
electrician or service person if you are in
doubt as to whether the outlet is properly
grounded. Do not modify the plug provided
with the product - if it will not fit the outlet,
have a proper outlet installed by a qualified
electrician.
This product is for use on a nominal 230 volt circuit and has
a grounding attachment plug that looks like one of the plugs
illustrated in Fig. 1. Make sure that the product is connected to
an outlet having the same configuration as the plug. No adaptor
should be used with this product.
This machine must be connected to the electrical ground to protect
the operator from electrical shock. The machine has a power cord
with two main conductors and one earthing conductor. Connect
the plug to the receptacle. The green or green and yellow conduc-
tor in the cord is the ground wire. Never connect this wire to any
terminal other than the ground terminal.
Figure 1
IEC-309 16A-6h/200-250 Vac
WARNING:
To avoid electrical shock always use this ma-
chine with an AC three-conductor electrical
system connected to the electrical ground.
Replace any worn, cut or damaged cords.
Replace any damaged plugs, receptacles,
or connector bodies. Do not move the
machine over an electrical cord. Always
lift the cord over the machine.
EXTENSION CORDS
Use only an approved extension cord with two main conduc-
tors and one earthing conductor. The machine has a power
cord with wire size 12 AWG or 2.5mm
2
.
WARNING:
To avoid motor burnout, if you use an ex-
tension cord, use an extension cord with
minimum wire size of 10 AWG or 4.0mm
2
.
Do not use an extension cord longer than 40
feet or 15 meters. Do not join two extension
cords.
WARNING:
To avoid electrical shock, do not cut, remove
or break the ground terminal. Do not try to
fit a three-terminal plug into a receptacle or
connector body that does not fit the plug. If
the receptacle or connector body does not
fit the plug, see your authorized American
Sanders dealer to get an authorized person
to make the connection.
NEMA L6-20P