8
9
EN
EN
Machine Transportation
Machine Set-up
WARNING:
The machine is heavy. Remove the motor
from the machine before transporting. Get
help loading the machine and motor.
To transport the machine, follow this procedure:
1. Make sure the power cable is disconnected from the electrical
outlet.
2. Disconnect the handle plug connection. See figure 1.
3. Remove the belt cover.
4. Remove the fan belt.
5. Loosen the motor bolt. Using the ¾" wrench, turn the motor bolt
counterclockwise. See figure 2.
6. Slide the motor forward.
7. Remove the drive belt.
8. Remove the motor from the chassis.
To re-assemble the machine after transporting, follow this
procedure:
1. Reposition motor on chassis.
2. Install the drum belt. Slide the motor back until adequate tension
is achieved in belt.
CAUTION:
To prevent damage to the floor surface,
make sure the drive belt is tight.
3. Resecure the motor to the chassis.
4. Install the fan belt.
5. Install the belt cover.
6. Reconnect the handle plug.
Figure 1
Figure 2
To set-up your machine follow this procedure:
1. Familiarize yourself with the machine and read all danger,
warning and caution statements. Make sure all operators of
this machine have read this Owner's Manual. If they cannot
read English, have the manual explained fully before allowing
anyone to operate the sander.
2. Locate the power supply. The receptacle should be
compatible with the plug. The receptacle must be grounded
and must be fused (30 amp) to avoid an electrical hazard.
3. Clip the dust bag to the elbow. Cross the strings on the dust
bag and draw tight over the flare on the elbow. Wrap the
string around the elbow and secure.
4. Wind the power cord through the cable arm. Keep the power
cord out of path of equipment.
How To Install The Abrasive
To install the abrasive, follow this procedure:
1. Prepare abrasive with template supplied.
2. Place backing of abrasive on the template. The template is
marked "This Side Up." Make sure the marked side of the
template is facing up.
3. Cut the abrasive to the exact lenght of the template.
4. Align one edge of the abrasive with a notch in the template.
5. Fold the other end of the abrasive over the end of the template
and crease.
6. Repeat steps 4 and 5 for remaining notch.
7. Lift the drum cover.
8. Put the smooth side of the abrasive against the sanding drum.
9. Put one end of the abrasive against the sanding drum slot (1).
See figure 3.
10. Turn the drum one revolution. Put the other end of the
abrasive in the drum slot (2).
See figure 3.
WARNING:
Disconnect power before
changing abrasive.
11. Tighten the abrasive.
To tighten the abrasive, follow this procedure:
1. The end wrenches are given with the machine.
Put a wrench around the nut at each end of the
durm (1).
See figure 4.
2. Make sure the flat sides of the nuts
are parallel with the drum slot.
3. Turn the wrenches the opposite rotation
until the abrasive is tight against the drum (2).
See figure 4.
12. Remove the end wrenches.
13. Close the cover.
NOTE:
When using #4 or 4½ grit abrasive,
remove the large grains from the folded
ends. To remove the grains, rub the
folded ends together.
Figure 3
Figure 4