Water pressure of 20 to 120 psi is required to correctly fill
the washer in the proper time. Pressures of less than 20 p.s.i.
may cause a failure in the water valve or the fill times to be
extended past what the washer controls will normally allow.
The water valve may also not shut off completely. Hot and
Cold water faucets must be within 4 feet of the back of the
washer for the inlet hoses provided with the washer.
NOTE: Accessory inlet hoses are available in various lengths up to 10 feet for faucets more than 4 feet from the back of the washer.
WATER
C A U T I O N
FAUCETS SHOULD BE EASILY ACCESSIBLE AND
TURNED OFF WHEN WASHER IS NOT IN USE TO
AVOID THE POSSIBILITY OF WATER DAMAGE.
DRAIN FACILITY
Recommended height of the standpipe is 36”. The drain hose must be routed through the drain hose clip to the standpipe. Standpipe must
be large enough to accept the outside diameter of the drain hose. The drain hose is attached to the machine at the factory.
For best performance the washer must be installed on a solidly constructed floor. Wood floors may need to be reinforced to minimize vibration
and/or unbalanced load situations. Carpeting and soft tile surfaces are contributing factors in vibration and/or tendency for a washer to move
slightly during the spin cycle. Never install the washer on a platform or weakly supported structure.
FLOORING
WASHER DIMENSIONS
27"
(
6
8.5 cm
)
43 1/4" min.
(109.9 cm)
36 1/4" min.
(92.1 cm)
27 1/2"
(
6
9.9 cm)
22 1/4"
(5
6
.5 cm)
1" min.
(2.54 cm)
MINIMUM CLEARANCES FOR CLOSET AND ALCOVE INSTALLATIONS:
Sides – 0 in. Rear – 1 1/2 in. Top – 2 in. Closet Front – 0 in. The
closet front must have a total unobstructed air opening of 72 sq. in.
minimum. A louvered door with equivalent air opening is acceptable.
ALCOVE OR CLOSET INSTALLATION
B
a
ck
C
le
a
r
a
nce
1 1/2“ min.
(2.54 cm)
Side
C
le
a
r
a
nce
0”
min
(0 cm)
Top
C
le
a
r
a
nce
2”
min.
(5.08 cm)
C
loset Front
0” min.
(0 cm)